PTS-40 SERIES

The element design features two 物那sections. Ringing section (a heated sec影生tion where the insulation is thermal機請ly separated) and pulling section wher年玩e the thermally separated insulation sl花低ug is wedged between two parallel edg去船es of the stripping element for an 房雪easy removal. Adjustable gauge 通電selector will block the entrance o暗吧f the wedged conductor to the nex黃現t and smaller opening thus prev舞哥enting any scraping of the conductor.請內 Although this section of the el文相ement also carries the current w好房hich heats the grooving section, it is 飛火not annealed (due to its greater wid場這ths and therefore much lower resistanc街廠e) and it retains its hard temper.女都 In addition, these edges are also s這廠upported by .025″ thick, hard temper們音 element support. This will allow鐵爸 pulling a slug as long as 12″ w會下ithout damaging the element. Pleas新鐵e note that conductors # 24-30 AW美訊G are stripped directly at the heated商站 end of the stripping element. Th為你e inner surface area of these w東志ires against the insulation is very sma綠志ll so there is no danger to dama科歌ge the element while pulling off the sl銀生ug. The stripping element is only .空河010″ thick (.008″ PTS-10) and 房年therefore the thermally cut groove wid紅影th is much narrower than the two e議關lement models offered by other manufa拍音cturers. This low mass thermal stripp光長ing technology means less power, fast玩服er heating time, shorter cooling t女匠ime fewer fumes and higher qua女和lity strip. The longevity of the elemen場雜t is also greatly extended because慢照 the annealed portion of the element is低村 used mainly for ringing (separati近麗ng) the insulation rather than pulli木慢ng off the slug.